Well, I´ve done everything nothing works.
I instaled elastix 1.6(kernel version - 2.6.18-164.e15 ; asterisk version 1.4.26.1 ; mISDN version 1.1.9.1), than i put the card on the on the server.
Detected the hardware with gui interface, and elastix give me this:
Port 1: TE-mode BRI S/T interface line (for phone lines)
-> Protocol: DSS1 (Euro ISDN)
-> Layer 4 protocol 0x04000001 is detected, but not allowed for TE lib.
-> childcnt: 2
* Port NOT useable for PBX (maybe there is already a PBX running?)
Now when i reboot the server elastix gives me the error on the console screen:
mdl_error|req(tei_12)
I dont know what the hell is this.
I keep configure the card doing the:
misdn scan
misdn config
misdn start
Changed the link to point to mutipoint, my line is point to multipoint.
and than edit the etc/asterisk/misdn.conf:
; adding the postfix 'ptp' to a port number is obsolete now, chan_misdn
; parses /etc/misdn-init.conf and sets the ptp mode to the corresponding
; configs. For backwards compatibility you can still set ptp here.
;
ports=1
[first_extern]
; again port defs
ports=1
; again a context for incoming calls
context=Extern1
; msns for te ports, listen on those numbers on the above ports, and
; indicate the incoming calls to asterisk
; here you can give a comma separated list or simply an '*' for
; any msn.
msns=*
; here an example with given msns
[second_extern]
ports=1
context=from-pstn
callerid=15
msns=*
and i changed the things that are underline
and than
i make asterisk -r
misdn show stacks
and give me this:
Connected to Asterisk 1.4.26.1 currently running on elastix (pid = 6169)
Verbosity is at least 3
elastix*CLI> misdn show stacks
BEGIN STACK_LIST:
* Port 1 Type TE Prot. PMP L2Link DOWN L1Link:DOWN Blocked:0 Debug:0
elastix*CLI>
Can someone help me here open vox people
Is the card that is malfuncioning or is missing some configuration
Hope someone could help me here
thanks in advanced.
hi:
what is the error:
=========================
Protocol: DSS1 (Euro ISDN)
-> Layer 4 protocol 0x04000001 is detected, but not allowed for TE lib.
-> childcnt: 2
* Port NOT useable for PBX (maybe there is already a PBX running?)
=========================
something is wrong here. by the way, after load the drivers, run : dmesg, do you see any errors?
from asterisk console, the layer1 and layer 2 are down, please double the physical connection.
or if still can not solve, you MUST give ssh to check that.
i dont know what happen but now its runing smoth i can make calls and receive inbound rotes , it´s fully working . i just changed the trunk to mISDN/1/$OUTNUM$ and i have
mISDN/g:isdn/$OUTNUM$ and in console run asterisk -r. i dont know what was wrong.
But now is fully working. if someone could tell me what happen i really appreciate.
thanks in advanced
Hello,
Actually, there is nothing special for it. Make sure the ISDN status is on UP or Active. And for the Trixbox GUI you must set the Trunk(mISDN/g:isdn/$OUTNUM$) to correct. In addition, the hardwares which around your system should be worked.